Blog & Insights
Building Management Insights
Expert advice, industry insights, and practical guides on building management systems, energy efficiency, and building automation technology.
Filter & sort
Current sort: Date: Newest first. Read filter: any.
149 articles found
HVAC SystemsFeatured
Why the Frost Stat Is on the Extract Side of a Plate Heat Exchanger
On a plate heat exchanger AHU the frost protection reads the extract, not the incoming fresh air, and engineers rewire it believing it to be a mistake. Why the ice forms on the extract side, how pack frost protection differs from the coil frost stat, and what actually triggers a defrost.
11 Oct 20269 min read
Read Article
Latest Articles
HVAC Systems
What Is a Recuperator AHU, and How Does It Compare With a Thermal Wheel?
A recuperator AHU recovers heat through a static plate pack; a thermal wheel does the same job with a rotating matrix and moves moisture with it. What separates them, the efficiency figures the manufacturers actually publish, and the different point schedule each type lands on a controls contractor.
11 Oct 20269 min
Read
BMS Technical
AHU Controls: How Air Handling Unit Control Sequences Actually Work
A full guide to AHU control sequences: start/stop and optimum start, the damper sequence, fan control, coil sequencing through a deadband, CO₂ demand ventilation, heat recovery by device type, both frost protections, and what to prove at commissioning before you accept a unit.
11 Oct 202612 min
Read
Case Studies
24V Window Actuator Wiring After a School Roof Replacement
Royal Harbour Academy, Ramsgate: eight weather-damaged 24V window actuator feeds re-cabled in 4 mm² fire-resistant cable, AHU control cabling drawn back and re-terminated, and extract fans wired back to the BMS during a roof replacement.
2 Oct 20267 min
Read
HVAC Systems
VAV Installation: TROX VAVs & Sontay CO₂ on a Trend BMS
A real VAV installation on a refurbished office floor: four TROX TA-Silenzio extract VAVs and Sontay duct CO₂ sensors wired back to a Trend panel two floors up. Core-by-core terminations, the signal-range and mode checks that decide whether the floor works, and what good looks like at handover.
28 Sept 20269 min
ReadMore Articles
Page 5 of 15
BMS Installation8 Jun 202614 min
BMS Installation in Kent: What Building Owners and M&E Contractors Need to Know
Read Article
Water & Utilities3 Jun 202612 min
Water Meter and Sub-Metering BMS Integration: Consumption Monitoring, Leak Detection, and BREEAM Credits
Read Article
Plant Rooms1 Jun 202611 min
Pressurisation Unit BMS Integration: Sealed System Protection and Fault Detection
Read Article
Water & Utilities27 May 202611 min
Rainwater Harvesting and Greywater Recycling: BMS Controls for Water Reuse Systems
Read Article
BMS23 May 202612 min
Why the Six-Week Summer Holiday Is the Best Time to Upgrade Your School's BMS
Read Article
BMS Technical22 May 202613 min
BACnet Protocol Explained: What It Is, How It Works, and Why Your BMS Needs It
Read Article
Water & Utilities22 May 202614 min
BMS for Sewage Treatment Plants: Process Control, Compliance Monitoring, and Remote Operation
Read Article
Plant Rooms20 May 202612 min
Booster Set BMS Integration: Pressure Control, Fault Detection, and Water Regulations Compliance
Read Article
BMS20 May 20269 min
How to Choose a BMS Installer in London (Without Getting Burned)
Read Article
Energy19 May 202611 min
Sub-Metering for Commercial Buildings: A Practical UK Guide
Read ArticleReady to Optimise Your Building?
Get expert advice on building management systems, energy efficiency, and building automation solutions tailored to your needs.
Get in Touch